wibako

Błąd 02 na wyświetlaczu klimatronika

Moderator: peckiel

Błąd 02 na wyświetlaczu klimatronika

Postprzez szczesniak22 » 19 Sty 2014 12:04

Marka i model maszyny: JCB JS 220 DL
Rok produkcji: 2010

Pojawia sie błąd 02 z książeczką na wyświetlaczu klimatronika, podpowie ktoś co on informuje i ewentualnie jak sie go pozbyć ? Z góry dziękuje

szczesniak22
Nowicjusz

  • Posty: 1
  • Rejestracja: 19 Sty 2014 11:58

Maszyna: Cat 320 DL, JCB JS 220 LC

Firma: UTWZ Łomża


Reklama

simmet

Błąd 02 na wyświetlaczu klimatronika

Postprzez Ambrozy » 23 Sty 2014 21:30

Witam. Coś takiego jest w opisach. Musisz sobie przetłumaczyć.
Kod: Zaznacz wszystko
Error Code 2 - Low Pressure Lock Out

Effect

The unit cannot cool the cab The compressor disengages.

Description
The low pressure switch opens for longer than 1 minute.
Causes
The system is undercharged.
Remedy
Check the continuity of switch (usually closed switch).
Check the gas in system and recharge, refer to table.
Causes
There is no power to the low pressure switch.
Remedy
Check for 24V at the switch.
Check the continuity between ATC control module pin 35 and switch.
Causes
There is a bad earth on the low pressure switch.
Remedy
Check the earth wire between ATC control module pin 36 and switch.
Causes
There is a defective switch.
Remedy
Replace the switch.

Note: If an Error code shows after one minute this can show a system error.
Note: If an Error code shows instantly this can show a wiring error.
Note: Battery reset may be required to remove the error after repair.



Pozdrawiam Ambroży.
Jeśli pomogłem kliknij pochwała

ıɯɐƃou ʎɹoƃ op ɹoʇıuoɯ zsɐɯ ǝz ʎzɔɐuz oʇ ɔɐʇʎzɔǝzɹd oʇ ǝıuɐʇs ʍ sǝʇsǝɾ ılǝzǝɾ

Awatar użytkownika
Ambrozy
Operator

  • Posty: 253
  • Rejestracja: 11 Mar 2007 17:37
  • Miejscowość: google
  • Pochwały: 17

Wyświetl posty z poprzednich: Sortuj według

Kto jest na forum

Użytkownicy przeglądający to forum: Brak zarejestrowanych użytkowników oraz 4 gości

nazwa

tekst alternatywny × Nie pokazuj więcej