FASTRAC 2135 problem ze sterowaniem

Proszę o pomoc odnośnie Fastraca 2135 (1998 r)
Mam problem ze sterowaniem skrzynią, ciągnik nie chce ruszyć ani do przodu ani do tyłu. Po przełączeniu reversu na wyświetlaczu tylko miga H lub R, a strzałka nie zapala się.
Wyświetlają się 2 błędy: T022 i T044.

Code: T022;
Description: Reversing lamp open circuit;
Possible Cause: For this circuit to be open, both reversing bulbs and the trailer reverse light relay (if fitted) must all have failed open circuit. Damaged wiring.
Action and Remedy: Check reversing light bulbs and relay (if fitted); refer to wiring diagrams.

Code: T044;
Description: R ram neutral switch/ram open circuit fault;
Possible Cause: All these switches appear to be OPEN and should be CLOSED. These codes can also result from attempting to use Selectronic with insufficient air pressure, causing insufficient cylinder movement to operate the switches normally , or air cylinder leaks which also cause slow or weak air cylinder movement. Failed switch (open circuit). Wiring faulty.
Action and Remedy: Check air pressure and operation of the switches. Check for air cylinder leaks. Check switch operation using a magnet and multimeter, or by using the diagnostics function of the WINGST. Check supply and return wiring between Transmission ECU and switches; refer to wiring diagram.


13.01.2012 Zero odzewu ze strony zainteresowanego.
Pewnie ciągnik poszedł na żyletki do lokalnego złomu...

kolego Ambrozy a mozesz napisac co to za kod T060 bo mam tez T022 i ten 60 fastrac 2115 z 98r

Witam.
Error Code :-
T060
Speed Triggers <1, <3 and >20 kph.
Eg The three speed triggers out of the EMS are telling the Transmsission controller that the tractor is going slower than 1 kph, slower than 3 kph and at the same time faster than 20 kph.
When this error code occurs Selectronic High and Medium Range are disabled to prevent damage to the gearbox.
Possible Cause :-
The three speed triggers <3, <1 and >20 kph are ouputs from the EMS and inputs to the Transmission Controller.

The EMS sets the speed triggers to <1, <3 and >20 kph if it detects a speed sensor fault. These settings make the tractor systems safe but useable. A faulty speed sensor would also create either of the 2 codes D020 or D021.
The T060 code could also be caused by a break in 20 kph signal line from the EMS to the transmission ECU.
Action and Remedy :-
Check for error codes D020 or D021.
If either of these two error codes have occured fix this first.
Check continuity of 20 kph line between the EMS and the Transmsission controller.
This is EMS pin Red 10 to Transmission Controller pin Black 17.

Kolego adam30 czy udalo Ci sie rozwiązac problem???
nie wiem czy komuś potrzebne ale błąd T022 u mnie polegał na wymianie żarówek od świateł cofania i już go nie ma .