przez lszkup » 12 Mar 2021 19:50
Nic się nie stanie jak ściągniesz obudowę, ale żeby dobrać się do czujnika trzeba ściągnąć cały sterownik hydrauliczny. Czujnik jest z wiązką elektryczną w tym sterowniku.
Zanim to rozbierzesz zrób test czujnika.
Speed sensor test using the turbine speed display
NOTE: a lamp test is performed prior to the speed sensor test and monitors all LEDs are operational.
SPEED SENSOR TEST REQUIREMENTS:
Powershift lever to be in reverse position, twist to upshift (keep the shift lever in this position during power up) turn the ignition on and start the engine.
With engine running return Powershift lever to neutral position and then place lever in forward and twist to upshift. Increase engine speed and compare with the table.
IMPORTANT: self test modes can only be started WHILE POWERING UP (ignition on). Leaving the self test mode is done by switching OFF the power to the Microprocessor (ignition off).
In this mode, driving is possible.
The LED corresponding with the table illuminates to indicate the torque converter turbine speed and increases with engine revs.
NOTE: application of the foot brakes during this test will reduce the turbine speed to zero.
Turbine Rev/Min LED
0 1 blinks
0 - 249 1 on
250 - 499 2 on
500 - 749 3 on
750 - 999 4 on
1000 - 1249 5 on
1250 - 1499 6 on
1500 - 1749 7 on
1750 - 1999 8 on
above 2000 8 blinks